How to Fix a Broken iPhone Charger with Heat Shrink Tubing

If you’ve ever had the frustration of a broken iPhone charger, you know how inconvenient and costly it can be to replace. However, there’s an easy and inexpensive solution: heat shrink tubing. By following a few simple steps, you can quickly and effectively repair your charger, saving you time and money.

Gather the Necessary Supplies

Before you begin, make sure you have the following items:

Heat shrink tubing in the appropriate size for your charger
A heat gun or other heat source
Scissors or a utility knife

Measure and Cut the Heat Shrink Tubing

Start by measuring the damaged area of your charger. You’ll want to choose a heat shrink tubing that is slightly larger than the diameter of your charger. Cut a piece of tubing that is a few inches longer than the damaged area.

Slide the Heat Shrink Tubing into Place

Gently slide the heat shrink tubing over the damaged area of your charger, making sure it covers the entire affected section. Position the tubing so that it overlaps with the plastic part of the plug slightly.

Apply Heat to Shrink the Tubing

Using a heat gun or other heat source, carefully apply heat to the tubing, moving the heat source back and forth to ensure even heating. As the tubing heats up, it will shrink and mold itself to the shape of your charger, creating a tight, protective seal.

Be cautious when using a heat source, as it can get very hot and cause burns if not handled properly. Keep the heat source moving and avoid holding it in one spot for too long.

Allow the Repair to Cool

Once the heat shrink tubing has fully shrunk and cooled, your charger repair is complete. Your charger should now be protected from further damage and ready for use.