Accidents happen, and when your laptop case cracks, it can be a frustrating experience. However, with a little bit of patience and the right tools, you can fix a cracked laptop case using everyday superglue. In this article, we’ll guide you through the process step by step.
Preparing the Area
Before you begin, make sure the area around the crack is clean and free of debris. Use a soft cloth or a cotton swab dipped in isopropyl alcohol to gently wipe away any dirt or dust. This will help the superglue adhere better to the surface.
Applying the Superglue
Once the area is clean, apply a small amount of superglue to the crack. Be careful not to use too much, as it can seep into the laptop and cause damage. Apply the glue in a thin, even layer, making sure to cover the entire length of the crack.
Squeezing the Plastic
After applying the superglue, use your fingers to gently squeeze the plastic together, aligning the edges of the crack as closely as possible. Hold the plastic in place for at least 5 minutes, allowing the superglue to begin bonding.
Curing Time
Once you’ve held the plastic in place for 5 minutes, you can release your grip. However, don’t move the laptop or apply any pressure to the repaired area for at least 24 hours. This will give the superglue ample time to fully cure and bond the plastic together.
Finishing Touches
After 24 hours, your laptop case should be securely repaired. If there are any rough edges or excess glue, you can carefully sand them down with fine-grit sandpaper. Be sure to wipe away any dust or debris before using your laptop again.
Remember, while superglue can be an effective temporary fix for a cracked laptop case, it’s not a permanent solution. If the crack is severe or the case continues to break, it’s best to replace the damaged parts or consider purchasing a new laptop altogether.