How to Fix a Non-Functioning SNES Classic: Troubleshooting Tips and Tricks

If your SNES Classic is not turning on or not displaying any image on your TV, don’t panic! There are several troubleshooting steps you can try to get your retro gaming console up and running again. Let’s dive in and explore the potential fixes.
Quick Check: Power and Connections
The first step is to ensure that the microUSB cable is properly inserted into both the SNES Classic and the power source. Make sure the cable is securely connected and the power adapter is providing sufficient power to the console.
Fix 1 – Open Up the System
If the basic power and connection checks don’t resolve the issue, it may be time to take a closer look inside the SNES Classic. Carefully open up the console and inspect the internal components for any visible damage or loose connections. 4

Accessing the Internal Components

To open the SNES Classic, you’ll need a small screwdriver. Gently remove the screws on the bottom of the console and lift off the top cover. Inspect the circuit board and connections, looking for any signs of wear, damage, or loose components.
Fix 2 – Use a Different Power Adapter
If the internal components appear to be in good condition, the issue may be with the power adapter. Try using a different microUSB power adapter, preferably one that is capable of providing at least 5V and 1A of power.
Fix 3 – Unplug the HDMI
Another potential solution is to unplug the HDMI cable from both the SNES Classic and the TV. This can help rule out any issues with the HDMI connection or the TV itself.
Fix 4 – Put the Console in Recovery Mode
If none of the previous steps have worked, you can try putting the SNES Classic into recovery mode. This mode allows you to perform a factory reset and potentially resolve any software-related issues.
To enter recovery mode, follow these steps:

Power off the SNES Classic.
Press and hold the Reset button on the console.
While holding the Reset button, power on the SNES Classic.
Release the Reset button when the Power LED starts blinking.

The console should now be in recovery mode, allowing you to perform a factory reset and potentially fix the issue.