How to Fix a Windows 10 Automatic Repair Loop and Get Your Computer Out of Repair Mode

If your Windows 10 computer is stuck in an automatic repair loop, it can be frustrating and prevent you from accessing your system. The automatic repair feature is designed to diagnose and fix issues that prevent Windows from booting properly, but sometimes it can get stuck in an endless loop. Fortunately, there are several methods you can try to get your computer out of automatic repair mode and back to normal operation.

Disconnect or Remove Recently Installed or Connected Devices

If you recently installed a new hardware device or connected an external drive, it could be causing compatibility issues that trigger the automatic repair loop. Try disconnecting or removing any recently added devices and see if that resolves the problem.

Run System Repair Tools (Chkdsk & SFC)

Windows includes built-in tools like Chkdsk (Check Disk) and SFC (System File Checker) that can help repair corrupted system files and fix disk errors. To access these tools:

1. Restart your computer and press F8 repeatedly to enter the Advanced Boot Options menu.

2. Select “Troubleshoot” and then “Advanced Options”.

3. Choose “Command Prompt” and run the following commands:

chkdsk /r c:

sfc /scannow

These commands will scan your system drive for errors and attempt to repair them.

Run the Windows 10 DISM Tool

The Deployment Image Servicing and Management (DISM) tool is another built-in utility that can help repair corrupted system files. To use it:

1. Boot into the Advanced Boot Options menu as described above.

2. Select “Command Prompt” and run the following command:

DISM /Online /Cleanup-Image /RestoreHealth

This command will download a fresh copy of the Windows image and replace any corrupted files.

Disable Automatic Startup Repair to Limit Boot Loops

If the automatic repair loop keeps occurring, you can try disabling the automatic startup repair feature to prevent it from running and causing further issues. To do this:

1. Boot into the Advanced Boot Options menu.

2. Select “Command Prompt” and run the following command:

bcdedit /set {current} recoveryenabled No

This will disable the automatic startup repair and allow you to boot into Windows normally.

If none of these methods work, you may need to perform a system restore or clean install of Windows 10 to resolve the issue. It’s always a good idea to back up your important data before attempting any major system repairs or reinstallations.