How to Restore Windows RE: A Comprehensive Guide

If you’re experiencing issues with your Windows operating system and need to restore it to a previous state, using System Restore can be a helpful solution. System Restore allows you to return your computer’s system files to an earlier point in time, without affecting your personal files. This can be particularly useful if you’ve recently installed a new application, driver, or update that is causing problems.

Accessing System Restore

To access System Restore, follow these steps:

Open the Start menu and type “Control Panel” in the search box.
Click on “Control Panel” to open it.
Search for “Recovery” in the Control Panel search box.
Click on “Recovery” and then select “Open System Restore”.
Click “Next” to proceed to the next step.

If you can’t access your computer’s desktop, you can also access System Restore from the Advanced Boot Options menu:

Restart your computer and press the appropriate key (usually F2, F12, or Del) to enter the BIOS or boot menu.
Select “Advanced Boot Options” from the menu.
Choose “Repair Your Computer”.
Select “System Restore” from the list of options.

Choosing a Restore Point

Once you’ve accessed System Restore, you’ll need to choose a restore point. Restore points are automatically created when you install a new application or driver, and you can also create a restore point manually.

To choose a restore point:

Select the restore point related to the problematic app, driver, or update.
If you don’t see the restore point you want to use, click “Show more restore points” to see additional options.
Click “Scan for affected programs” to see a list of items that will be deleted if you restore to this restore point.
If you’re okay with the deletions, click “Next” to continue.

Keep in mind that restoring your system to a previous point will remove any applications, drivers, and updates installed after the restore point was created.

Completing the System Restore Process

Once you’ve chosen a restore point and confirmed your selection, follow these steps to complete the System Restore process:

Click “Finish” to start the restoration process.
Click “Yes” to confirm that you want to restore your system.
Your computer will restart, and the System Restore process will begin.
After the restoration is complete, your computer will restart again, and a status report will be displayed.

If you’re not satisfied with the results of the System Restore, you can undo the restore or restore to a different restore point.

Enabling System Restore

System Restore is enabled by default, but you can check its status and make changes if needed:

Open the Start menu and type “Create a restore point” in the search box.
Click “Open” to access the System Properties window.
If the “Protection” status for your system drive shows as “On”, System Restore is enabled.
If the “Protection” status shows as “Off”, select the system drive and click “Configure”.
Select “Turn on system protection” and set the maximum usage of disk space for restore points (5-10% is recommended).
Click “OK” to save your changes and enable System Restore.

Keep in mind that the maximum usage setting will determine how much disk space is reserved for restore points. As space fills up, older restore points will be automatically deleted to make room for new ones.

In conclusion, System Restore is a powerful tool for troubleshooting and resolving issues with your Windows operating system. By following the steps outlined in this guide, you can access System Restore, choose a restore point, and complete the restoration process. Remember to enable System Restore and create restore points regularly to ensure that you have the option to roll back your system if needed.