Where should curtain rod brackets be placed?
Each bracket should be placed at the height you previously determined and about four to six inches from the side of the window frame. (This will allow you to open the curtains completely.) Check to make sure your pencil marks are level otherwise the entire window treatment will be crooked.
How wide should curtain rod brackets be?
Curtain rod brackets are available in two standard sizes: 5/8-inch and 1-inch widths. You must install curtain rod brackets before you can mount a curtain rod or hang curtains.
How far should a curtain rod extend past window?
As a general rule, drapes will be open during the day, so make sure the curtain rod extends at least four inches on each side of the window’s inside frame. To create the illusion of a wider window, extend the rod up to 10 inches beyond the window’s frame.
Which side of curtains should be inside on door?
But the fabric side (also described as the woven or rough side) is made to face the window because of the durability. Face the fabric side out to avoid yellowing or sun damage, which will preserve the lifespan of your curtains.
Do you need middle bracket on curtain rod?
A center bracket is needed in almost any length greater than 5 to 6 feet, if you want to avoid any sagging. However there are “C” rings that will go over the bracket so that the drapes/curtains can be pulled to one side (either side, in fact).
How far should curtain rods stick out from wall?
General Installation Recommendations. When installing curtain rods, hang the rod so that it extends at least 3 or 4 inches beyond the window on each side. This allows your curtains to overlap both the window and the wall to prevent light from leaking in around the window’s edges.
How many brackets do I need for curtain rod?
Count how many brackets are included with the curtain rod. As a general rule, there should be at least one bracket for each outside corner of the window, and one bracket in the center. Add more brackets if the expanse between the middle and outer brackets is more than three feet.
Can you hang curtain rods without drilling holes?
Dowels and Sticky Hooks A slim wooden dowel is a beautifully understated way to hang curtains. And the beauty of using a sticky hook instead of drilling holes in the wall is that if you decide the curtains look too low or too high, you can move the rod and hooks without any damage.
How far should curtain Pole be either side of window?
For a typical window without architraves, we recommend poles/tracks overhang the width of the window by not less than 15cm (6″) each side (excluding finials). Mark the pole/track and check your measurements again. Then cut the pole to your required width (excluding finials).
How far below window should curtains hang?
While fashion once dictated a “flood level” bottom line for curtains—one that hung just past the window sill, short enough that it would not get wet in a flood—today, style calls for curtains to either hang down to within ½-inch of the floor or even puddle slightly.
How do you extend curtain rod brackets?
Place the brackets into position on the wall, lining up the screw holes on the brackets with the pilot holes on the wall. Screw the brackets to the wall with the provided screws. Install the curtains onto the rod and attach the rod to the brackets. Adjust curtains as necessary.
Do sheer curtains go in front or behind?
When the sheer curtain is the top layer, they’ll hang over your blackout curtains. This lends a visually interesting look for your windows, especially if the two fabrics are paired well based on their pattern and palettes. Sheers are always visible being the top layer.
Which side of the blackout curtain faces the window?
While the lining will keep the light out of the room regardless of how it is positioned, some manufacturers recommend aligning it so the textile side faces the window, simply to reduce sun exposure to the specialty coating and to help prevent it from damage from rubbing against the window frame while the curtains are.
Which side of curtain lining faces out?
The right side of the lining orients to the window, so you need to know how to determine the right and wrong side before you start your construction. The right side of the lining faces out the window.
How do you support the middle of a curtain rod?
If the curtain rod stands too far from the window for the pipe rail tie to work, you can make a support from a long, heavy-duty screw hook. Screw hooks are similar to eye hooks, which are heavy screws with a loop or ring at the end. Instead of a loop, screw hooks are shaped like a U or a C.
How far can a curtain rod span without support?
Having said that, a 2 inch or 3-inch diameter pole can span a distance up to a full 12-feet without flexing or bowing using only two end brackets.
How do I keep my curtain rod from sagging in the middle?
10 Clever Ways to Fix a Sagging Curtain Rod at Home Realign the Support Brackets. Provide Extra Support Brackets. Insert Another Support Rod. Change Your Fabric Material. Reduce the Cotton’s Length. Use a Barrier to Protect Your Curtain. Get a More Durable Curtain Rod. Replace Your Support Brackets.