Ribbon cables, also known as flat cables, are commonly used in electronic devices to connect different components. However, these cables can become damaged over time or due to improper handling, leading to a torn or severed ribbon. If the wire becomes damaged, the ribbon will not be able to achieve a proper connection. Fortunately, it is possible to repair a broken ribbon cable by recreating the wire connections with a metallic conductive substance.
Preparing the Cable
Before you begin the repair process, you will need to prepare the cable. First, use a sharp knife or scissors to carefully cut the torn section of the cable, ensuring that you have two straight edges to work with. If cutting would remove too much length, you can try to cut or tear the untorn area as straight as possible to get two halves and then follow the instructions below.
Next, use a single-edge razor blade to scrape the top protective layer from over the broken traces on both halves of the cable. Be careful not to remove the copper traces, as they may break off. Take your time with this step, as it can be a slow process.
Soldering the Connections
Once the cable is prepared, it’s time to solder the connections. Start by spreading a thin layer of solder paste across all exposed copper traces on both halves of the cable. Use a soldering iron to heat the paste so that it adheres to the copper part of the cable.
Next, use masking tape to securely tape down the top exposed foil side of the cable first. Then, lay the copper side down, half over the edge of the tape, lining up as perfectly as possible and overlapping by about 1/8 of an inch. Apply more masking tape to hold this side in place as well.
Apply a small amount of solder paste at the junction of the two pieces. Heat up the top foil until some of the solder paste is pulled under the two layers. Use a flat blade screwdriver or razor blade to hold the top layer down while sliding off the soldering iron and putting the blade in its place until the solder has cooled for about 30 seconds.
Check the connections to see if they are okay. If the joint does not look good, reheat and separate the two layers, then repeat the process as necessary. If there is too much solder, use solder wick to remove it. If there is not enough solder, apply more solder paste and reheat the joint as before.
Finally, use a UV solder mask to cover the repaired area and apply UV light to cure it, ensuring that the repair is secure and protected.