If your car’s cigarette lighter or 12V accessory socket has stopped working, don’t despair. In many cases, the issue can be easily fixed with a few simple troubleshooting steps and some basic knowledge. In this comprehensive guide, we’ll walk you through the most common problems and solutions for getting your vehicle’s 12V power source back up and running.
Checking the Fuse
One of the most common reasons for a cigarette lighter or 12V accessory socket to stop working is a blown fuse. To check the fuse, you’ll need to locate the fuse box, which is usually found under the hood, beneath the steering wheel, or in the trunk. Consult your owner’s manual for the exact location in your vehicle.
Once you’ve located the fuse box, use the legend on the panel’s cover to pinpoint the lighter’s fuse. Pop off the plastic cover or lid and use tweezers or needle-nose pliers to remove the fuse. If the wire inside the fuse is broken or blackened, it needs to be replaced.
To test the fuse, use a multimeter set to check for continuity. Touch one probe tip to each end of the exposed part of the fuse. If there is no continuity, the fuse has blown and needs to be replaced. Make sure to use a replacement fuse with the same amperage rating as the original.
Cleaning the Socket
If the fuse is working properly, the problem may lie within the cigarette lighter socket itself. Over time, debris and other objects can accumulate in the socket, preventing a proper connection. To clean the socket, use a can of compressed air to blow out any loose debris. You can also use a toothpick or other non-metallic object to gently remove any stuck-on material.
Be careful not to damage the socket’s delicate components. If you’re not comfortable cleaning the socket yourself, consider taking your vehicle to a professional mechanic for assistance.
Replacing the Lighter Plug
If your car has a cigarette lighter with an actual push-in plug (or “button”) that can light cigarettes, the plug itself may be the problem. If so, pull it out, take it to an auto parts store, and buy a matching replacement. Make sure to check the fuse before installing the new plug, as a blown fuse can also cause the lighter to stop working.
To install the new plug, simply push it into the socket until it clicks into place. Test the lighter to ensure it’s working properly before reassembling any panels or covers.
Testing the Socket with a Multimeter
If you’ve checked the fuse and cleaned the socket but the lighter still isn’t working, the socket itself may be faulty. To test the socket, use a multimeter set to check for voltage. With the vehicle’s ignition in the “on” position, touch the red probe to the metal circle at the bottom of the socket and the black probe to the side of the socket.
If the multimeter reads close to 12 volts, the socket is receiving power and should be working. If the reading is significantly lower, the socket may need to be replaced. Consult a professional mechanic for assistance with socket replacement, as it can be a complex process depending on your vehicle’s make and model.
Preventing Future Problems
To keep your cigarette lighter or 12V accessory socket working properly, avoid plugging in devices that draw too much power. Many sockets are fused at 10 or 15 amps, so using an inverter or other high-powered device can cause the fuse to blow.
Additionally, be mindful of what you plug into the socket. Food crumbs, stones, or dirt can easily fall into the socket and cause a short circuit. If you do spill something in the socket, clean it out immediately to prevent corrosion and other damage.
With a little bit of knowledge and some basic troubleshooting skills, you can keep your car’s cigarette lighter or 12V accessory socket working like new. By checking the fuse, cleaning the socket, and replacing worn-out components when necessary, you can avoid the frustration of a non-functioning power source and keep your devices charged and ready to go.